top of page

2024 Crown Vic

Rules and/or regulations set forth here in are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. These rules shall govern all events and by participating in these events, all participants are deemed to have complied with these rules.
NO EXPRESSED OR IMPLIED  WARRANTY OF SAFETY SHALL RESULT FROM PUBLICATION SO FOR COMPLIANCE WITH THESE RULES and REGULATIONS.
They are a guide and are in no way a guarantee against injury or death to a participant, spectator,or  official.TR Speedway retains the right to make all decisions and reserves the right to make any rule changes/amendments with dispute or appeal.  The creation of an  affordable, entry level way to enter stock car racing. Keeping the car's stock is the priority. Only Ford CrownVic, Mercury Grand Marquis,or Lincoln Town Car 1992 or newer.

1.BODY
1.1-Remove all glass and trim.
1.2-Remove head lights and taillights.
1.2-1-may cover with sheet metal.
1.3-Doors must be welded.
1.4- Hood and trunk must have a minimum of 2 hood pins.
1.4-1-locks must be removed.
1.5-Stock steering column ,may use a quick disconnect steering wheel.
1.6- Dash may be removed and replaced  with sheetmetal.
1.7-All air bags must be removed.

2.SUSPENSION
2.1-Stock for make and model.
2.2- All replaced parts must be OEM replacement or same stock parts only.
2.3-May adjust as factory adjustments allow only.
12.4- No Spring Rubbers allowed.
2.5- No air ride allowed.

3.WHEELS&TIRES
3.1-Stock stee lor aluminum wheels only. (no racing wheels)
3.1-1- All 4 must be the same size and offset.
3.2- These tire sizes only 235/55/17, 225/60/16, and 215/70/15.
3.2- All season tires only. No performance or directional allowed.

4.ENGINE
4.1- Must remain entirely stock
4.6 LSOHC engine.
4.2-Pump gas only. (fuel kill switch may be relocated or kill all switch added)

5.TRANSMISSION
5.1-Must remain entirely stock.

6.REAREND
6.1- Must remain entirely stock
6.2- Factory 3.73 gear ratio max.
6.3-Factory posior weld the spider gear. (No after market lockers)

7. ROLLCAGE & SAFETY
7.1- Must have seamless tubing 4-point roll cage only with X braced hoop behind driver with minimum of 3 door bars with vertical b racing from top to bottom. Cage must be 1.5”x.095” tubing. Frame must have minimum 1/4-inch steel plate welded to frame where bars connect. 7.2- Approved racing seat and 5-point harness. Must be safely secured to the roll cage.
7.3-Working fire extinguisher or fire suppression system.
7.4-Properly mounted window net.
7.5-Battery may remain in stock location or moved behind driver, must  be securely mounted, and covered if moved.
7.6-Radiator must contain water only.
7.7-2-1/2’’ max exhaust pipe run to passenger side or to rear. May remove catalytic converter.

PROTEST&CLAIM Visual protest only - $25-Must bed one 30 mins before event Protest 3 items for $300 , $100 acceptance, track keeps $100

Engine or Transmission Claim- $700 (no bolt ons) track keeps $100
2- $500 back-buy ECU Claim- $125- $75 back-buy

bottom of page